Published at Monday, 05 November 2018. Storage Shed. By Joyce Ortega.
So next to install the roof brace here you line it up into the holes line up with the holes here and then you're going to install the roof on top of that, so it fits into the groove for it. That'S the roof laid on top easy peasy. There are grooves for all these to fit in as it goes down and the holes line up there. Well, they should there. You go those line up on either side here, so it turns out that you're actually supposed to have access to the back, so you can fill in these pilot holes or feel it realness here so I'll, be sliding it out and doing that. Okay. So now the top is bolted on here and not going to do the front yet because before you do the front, you have to lift it up and attach the hinges for the doors.
On this little lip here, you're going to drill a hole through both the wall and the floor, because at the very you're going to get your multiple pieces because at the very end we're going to screw it all down and secure it through those holes. Okay, so the next step we put wall, DS connected it to wall G, which we just put in it fits in with these. They fit load it up the top and you between all these holes. You put the slots in you put them in there and then you push down, and I had to give mine a few whacks with the rubber mallet to get it down all the way. But you lock them together. Like that and remember, we are punching out the holes at the top four screws, we're just mirroring exactly what we just did with G, but this time we're doing it with each step one, but just the reverse, edit.
The first step is to cut these out and these holes as well all along our side, the side all along the side and down, but mine were already done. So the next step was to use a 1/8 inch bit to drill a little hole there and careful, though, to only drill a hole through this side and not through the side to place it roughly where you want them to be so all the panels are actually Labeled there are letters and which direction is up so this one's upside down, and you can see that on the backside of all of them, they all have their letters, so you know exactly where they go so before you install anything, go through and punch these holes Out using a screwdriver as those are your the screw holes that you'll need access to, okay, so we're putting in we're putting in the left wall, which is G punched out the holes in the top and then at the bottom.
Any content, trademark’s, or other material that might be found on the marxistoutlook.com website that is not marxistoutlook.com’s property remains the copyright of its respective owner/s. In no way does marxistoutlook.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 marxistoutlook.com. All Rights Reserved.