Published at Wednesday, 07 November 2018. Deck Box. By Christy Franco.
I wanted these to have a little foot underneath the whole thing, so I cut some 1-inch scraps to use as an offset to hold the bottom frame off the ground, then up with the legs on the ground right up in the corner and drove in screws from All three sides to tie each one of these together, really strong with all the uprights connected. I stood it up on its end and then laid the top frame down. I flip this whole piece over so that I was working on it upside down and this let me connect the top of the uprights to the bottom of the top frame, so we're confusing, I know, but once you flip it over and makes more sense the long Two by fours were purchased at ten feet, so I didn't have to cut those but the one by fours I use to face the whole thing for twelve points, so I did have to cut off some extra from them and use those extra pieces to cover the End I screwed one-piece end they used a couple of screws as a spacer and added the next one and the next one and followed that all the way up the sides.
I did the same procedure for the front and the back in the other end. No matter how good you are picking out pieces of lumber, none of them are going to be perfectly straight. I find it's best to start at one end put one screw in then your spacer right in the middle screw the middle piece in and then work to the other end that allows you to bend it as you need to to get all the way across and get it as straight as possible, then go back and add a second screw to each one of these connections after this was completely wrapped in one by fours I laid out some decking boards across the top. Then I took them off and cut them in half these were also purchased at ten feet, so it didn't have to cut them to the length just right down the middle. I laid them back in place, matching them up with their op cut and then use two five fours to span all four pieces. You have to make sure to drive in screws from the bottom and from the top side because once these start to warp, they will separate unless there are screws coming in from both directions.
This is just a hand. Hold right in the middle of each one of these sides, I put a little bit of an angle on it, but you could always use a router to round it over. If you wanted to make it even fancier, then I can finally hide away all the noodles and pool cleaning supplies there. It is super quick and easy. I did this an entire day and I was filming so if you weren't filming this would probably just take you a couple of hours. Obviously, you can change the scale of this to fit your space. I just made it so it would fit between these two bushes. In this one little area and if you needed to put heavier things on the inside, you could put some slats of wood across there just to give it a solid bottom. In my case, though, I'm going to be storing mostly pool noodles and supplies, so it doesn't really need to be strong down there, because this wood is treated. It is a little wet, so I have to wait for it to dry out before I can sand off the markings on the top of it. Those will come off pretty easily and then once it fully dries out.
Any content, trademark’s, or other material that might be found on the marxistoutlook.com website that is not marxistoutlook.com’s property remains the copyright of its respective owner/s. In no way does marxistoutlook.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 marxistoutlook.com. All Rights Reserved.